User Manual
Table Of Contents
Insert the dowels supplied to the centre cabane and
the lower fuselage.
Remove
Before glueing the centre top plate in place a decision needs to be
made. If your intenons for this Panic are to go electric now is the
me to fabricate a tray system and hatch for your baery.
If you have chosen to go for the IC setup then
please glue the top plate in place.
Now the fuselage is complete sand all edges and round
the rear fuselage corners. How much you round the rear
of the fuselage is up to you but weight can be saved by
increasing the radiuses. You can now glue the servo tray
in place making sure the rear of the tray aligns with the
reinforcing edge. Make sure you leave adequate space
between the two servo trays to fit your servos. If you have
chosen to put the rudder servo inside the fuselage and
you are installing a throle servo you will need to remove
the parts shown in the image below.