User Manual

Pywood re-enforcing
Firewall
Balsa fuselage frame
90
Use servo tray as a spacer(do not glue in place).
Trim to allow the triangle secon to lay flat.
Repeattheprocessasperthebottom
sectionoftrianglestrip.Remembertorun
thetrianglesectiontothepositionyou
markedjustinfrontofthetailplaneseat.
The rear of the fuselage should look like this.
Repeat the process on the other fuselage
frame but to suit the opposite side.
Glue the firewall in place in the recess createdbythereinforcing
plyandthefrontedgeofthefuselageframe.Itisimperativethis
isgluedintheverticalpositionandallowedtodry.
Note: please use image on next page in conjuncon with
this step.
Glue the other side of the fuselage in place at the firewall only.
Use the servo tray as a temporary spacer to keep the fuselage
frames parallel but do not glue the servo tray in posion.