Installation Manual

Lynx NGT-9000
Installation Manual
0040-17001-01 (Revision W) Installation Page 2-24
2.3.9 Remote Mounted Lynx NGT-9000 Installation
This procedure assumes that the mating connector and Antenna Cables are assembled.
NOTES
1. Tighten all screws to snug unless specific torque instructions are given.
2. The ruggedized mounting tray must be channel mounted for installations
in a high vibration environment.
1. Place the Mounting Tray P/N 9002018-001 (item 1) in the location selected in paragraph 2.3.2.
2. Determine centers for mounting holes, and drill for required fasteners. See Figure 2-15.
3. Secure the Mounting Tray P/N 9002018-001 (item 1) in place using #8-32 fasteners and
lockwashers. Torque fasteners (screws) to 20 In-Lbs.
4. Secure P1 Mating Connector to Rear Plate P/N 9000-17025-02 (item 2) using Nut Plate P/N 9000-
17034-01 (item 6) and 2 Screws P/N NAS514-P-440-7 (item 3).
5. Secure assembled Antenna Connector to Rear Plate P/N 9000-17025-02 (item 2) using Nut Plate P/N
9000-17036-01 (item 5) and 2 Screws P/N NAS514-P-440-7 (item 3).
6. Attach end of Cable Ground Straps P/N 9020-17002-01 (item 27) to Rear Plate (item 2) using 2
screws P/N 2000-10087-01 (item 22).
7. Secure Rear Plate (item 2) to Mounting Tray P/N 9002018-001 (item 1) using 4 Screws P/N
NAS514-P-440-5 (item 4).
8. Lay unit flat against the base of the tray. Push unit into the connectors allowing the alignment guides
to settle the unit into place.
9. Secure the unit to the tray using the thumbscrew in front of the unit. Tighten thumbscrew (3/16 hex)
until unit front plate contacts the tray face.