Installation Manual

Lynx NGT-9000
Installation Manual
0040-17001-01 (Revision W) Installation Page 2-17
2.3.7 P1 Mating Connector Assembly
Installer must take into consideration the length of the wiring harness to ensure an adequate service loop
before installing the unit. Refer to Figure 2-9.
1. Assemble Connector Pins P/N M39029/57-354 (item 11) to wires using Crimp Tool M22520/5-01
and Insert M22520/5-05.
2. Secure Backshell P/N 9010-17012-01 (item 9) to P1 Mating Connector P/N 9080-17006-01 (item
14) using 4 Screws P/N 2000-10085-01 (item 7).
3. Remove liners from two Wire Clamp Pads P/N 9000-17132-01 (item 30) and attach to back of both
Wire Clamps P/N 9000-17076-01 (item 10).
4. Insert aircraft wiring and wires of the DCM to the P1 Mating Connector (item 14).
5. Route wire shields between Wire Clamp Pads (item 30) and Backshell (item 9).
6. Secure two Wire Clamps P/N 9000-17076-01 (item 10) and 1 Cable Ground Strap P/N 9020-17002-
01 (item 27) to Backshell (item 9) using 6 Screws P/N 2000-10087-01 (item 22). (Refer to Figure 2-
13 for the installation location of the other side of the cable ground strap.)
7. Secure Wires to Wire Clamps (item 10) using Cable Ties P/N 1040-10002-01 (item 26) as required.
Figure 2-9: P1 Mating Connector Assembly