Installation Manual

Lynx NGT-9000
Installation Manual
0040-17001-01 (Revision W) Maintenance Page 4-44
Table 4-4: List of Fault Log Messages
FAULT ID/ CODE
(HEX)
FAULT DESCRIPTION CORRECTIVE ACTION
0x00006008
ARINC 429 Receiver #2 Loop Back
Failure causes a reset
Log the fault.
0x00006009
Control Panel Input Fail
Transponder External failure
Check Control Panel wiring.
Reboot the unit and check if the fault
persists. Contact ACSS Field Service
before removal.
0x0000600A
WX-500 Synchro Heading Input Fail
Fault causes the following:
ADS-B In External Degraded
TAS External Degraded
TCAS External degraded
Lightning External Degrade
Check WX-500 wiring to the synchro
heading input and Synchro LRU.
Reboot the unit and WX-500 system and
check if the fault persists. Contact ACSS
Field Service before removal.
0x0000600B Lightning Sensor Fail Check WX-500 and Antenna.
Reboot the unit and WX-500 system and
check if the fault persists. Contact ACSS
Field Service before removal.
0x00006803
Clear Gillham C Bit Error
Log the fault.
0x00006804
Clear RS232 Altitude Input Fail
Log the fault.
0x00006805
Clear ARINC 429 Altitude Input Fail
Log the fault.
0x00006806
Clear ARINC 429 AHRS Input Fail
Log the fault.
0x00006807
Clear ARINC 429 Receiver #1 Loop
Back
Log the fault.
0x00006808
Clear ARINC 429 Receiver #2 Loop
Back
Log the fault.
0x00006809
Clear Control Panel Input Fail
Log the fault.
0x00008xxx
Fault codes with the "8xxx" are all
clear codes that log the moment a
fault has been cleared.
Log the fault.