Installation Manual

Lynx NGT-9000
Installation Manual
0040-17001-01 (Revision W) Installation Checkout Page 3-42
• If configured the Flight ID Screen is shown before the normal operation screen is shown. See
Figure 3-25.
The Flight ID Number is entered using the keypad. For Release 1 and 2 the keypad will change
to numbers after three alpha characters are entered. For Release 3 or greater tap the “123”, “A-
M” or “N-Z” button to change the keyboard buttons as needed. When complete, tap the Done
button to proceed.
Screen seen on Release 1 or Release 2 Screen seen on Release 3 or greater
Figure 3-25: Example of Flight ID Input Screen
5. Press the System Test button located on the left screen. See Figure 3-26. The system test is used to
test the internal unit operation and determines if the external inputs are providing valid data. Failures
due to external input data loss will be cleared once those inputs are working properly.
6. During the System Test, the user functions are disabled and the right screen shows a preset traffic
display with the message "Self Test In Progress" at the top of the screen. See Figure 3-26. The left
screen shows the test results of the functional areas indicated and not specific test failures.
NOTES
Release 1: Functions that are not part of the installation (no function
activation) will not be shown.
Release 2: TAS, ATAS, and TAWS are listed with a "disabled"
indication if not installed. FIS-B is removed from the list if it is disabled.
Release 3: TCAS listed with a "disabled" indication if not installed.
Figure 3-26: Example of System Test Results