Installation Manual

Lynx NGT-9000
Installation Manual
0040-17001-01 (Revision W) Installation Checkout Page 3-20
3.7.1 Aircraft Specific Options
From the MPC (MAT) select Setup… ConfigurationModifyAircraft Specific. See Figure 3-10. Enter
the information specific to the installation for the intended certification.
Figure 3-10: MPC (MAT) –Aircraft Specific Options
1. Tail Number: Enter the tail number the aircraft that the unit is being installed.
• For aircraft that have tail numbers which include a hyphen, the hyphen should be omitted when
entering the tail number in this field. When ground testing the transponder, the broadcast tail
number may not be reported correctly on some test equipment for some countries.
2. Mode S Identifier: 24 bit ICAO address code. Eight octal digits. The code can be obtained from
either the aircraft registration certificate or the N number inquiry page
http://registry.faa.gov/aircraftinquiry/
.
3. Transponder Diversity Enable: Select Disabled or Enabled. This function must be enabled for
installation with Diversity (NGT-9000D, and D+, or NGT-9000RD, and RD+).
• This feature requires a Mode S Identifier to be entered.
• This feature requires a function activation code.