User's Manual
Table Of Contents
- Eclipse ODU 600 5.8 GHz ISM Band Installation Manual Rev.001
- Copyright & Terms of Use
- Aviat Networks Support
- Eclipse Product Compliance Notes
- Contents
- Volume I: Introduction and Safety
- Volume II: System Overview
- Volume III: Installation
- Chapter 1. Introduction to Installation
- Chapter 2. ODU Installation
- Chapter 3. INU and INUe Installation
- INU/INUe Overview
- Installation Requirements
- Installation Procedure
- Plug-in Installation
- INU/INUe Cable Assemblies
- DAC Trib Connectors and Cables
- NMS Connectors and Cables
- NMS 10/100Base-T Connector
- Maintenance V.24 Connector
- Auxiliary and Alarm Connectors and Cables
- AUX Data Cable: Async, HD26 to Wirewrap, 2 m
- AUX Data Cable: Sync, HD26 to Wirewrap, 2 m
- AUX Data Cable: Async, HD26 to 3 X DB9, 1 m
- AUX Data Cable: Sync, HD26 to 3 X DB9, 1 m
- AUX Data Cable: Async, AUX HD26 to AUX HD26, 1 m
- AUX Data Cable: Sync, AUX HD26 to AUX HD26, 1 m
- AUX Alarm I/O Cable: HD15 to Wirewrap, 2 m or 5 m
ECLIPSE INSTALLATION MANUAL
Weatherproof the external N connector assembly using mastic and vinyl tape. See
Weatherproofing on page 69.
Install a jumper cable from the ULA to the indoor radio unit.
Building Entry Installation
Determine where the ULA is to be located. This should be just inside the building,
and as close as practical to the entry point – no more than 1m (3ft) from the entry-
way. A location must be chosen that ensures that the body of the ULA will not be in
electrical contact with any metal structure (cable tray or similar support structure).
If necessary it should be mounted to the metal support structure using a ceramic or
porcelain
insulator.
Figure 2-13. ULA Installed Inside
Item Description
1 Lightning Surge arrestor
2 Ground wire
2a Preferred path for ULA ground wire
3 Wall gland
4 Internal master ground bar
5 External ground bar
6 Cable ground kit
7 ODU cable
8 Indoor unit to arrestor jumper cable
9 Equipment rack
10 Site ground system
260-668066-004 AUGUST 2013 67