User's Manual

ECLIPSE INSTALLATION MANUAL
These and other cable accessories can also be purchased individually or in quantity.
Contact Aviat Networks or your supplier for details.
Coaxial Cable Installation Requirements
Table 2-3. Installation Requirements for ODU Coaxial Cables Summary
Task Required con-
siderations
Explanation
Installing
connectors
Crimped connectors Always use the crimp tool designed for the crimped
connectors/cable being used. A recommended crimp
tool for connectors used with the RG-8/U type cable
is available from Aviat Networks as Part No. 840-
600203-001.
When removing the jacket
- all coaxial cable
Take great care when removing the jacket to keep
the outer conductor intact. A scored outer
conductor will weaken the cable and, for a solid
outer cable, can cause the outer conductor to break
or crack when subsequently bent.
When removing the jacket
-solid outer conductor
cable
Always use the cut-off and strip tool specifically
designed for the cable being used.
Fastening TypeN
connectors
Tighten TypeN connectors (male to female) by
hand only.
Weatherproofing All outdoor connections must be made
weatherproof. Refer to Weatherproofing on page
69.
Planning the
route
Protection for the cable The route chosen must provide physical protection
for the cable (protection against accidental
damage).
Keep access to tower and
services clear
The cable must be positioned so that there is
unimpeded access to the tower and to services on
the tower.
Ease of running and
fastening
Use a route which minimizes potential for damage
to the cable jacket and avoids excessive cable re-
bending.
Installing the
cable
Cable jacket Keep cable clear of sharp edges
Cable support Rod support kits or similar must be used across
unsupported sections of the cable run so that the
cable cannot flex in the wind.
Bend radius Ensure the minimum bend radius for the cable is
not exceeded.
Cable ties Use one UV-resistant cable tie (from the ODU cable
kit) every 1m (3 ft) or less, of cable.
260-668066-004 AUGUST 2013 59