User's Manual
Table Of Contents
- Eclipse ODU 600 5.8 GHz ISM Band Installation Manual Rev.001
- Copyright & Terms of Use
- Aviat Networks Support
- Eclipse Product Compliance Notes
- Contents
- Volume I: Introduction and Safety
- Volume II: System Overview
- Volume III: Installation
- Chapter 1. Introduction to Installation
- Chapter 2. ODU Installation
- Chapter 3. INU and INUe Installation
- INU/INUe Overview
- Installation Requirements
- Installation Procedure
- Plug-in Installation
- INU/INUe Cable Assemblies
- DAC Trib Connectors and Cables
- NMS Connectors and Cables
- NMS 10/100Base-T Connector
- Maintenance V.24 Connector
- Auxiliary and Alarm Connectors and Cables
- AUX Data Cable: Async, HD26 to Wirewrap, 2 m
- AUX Data Cable: Sync, HD26 to Wirewrap, 2 m
- AUX Data Cable: Async, HD26 to 3 X DB9, 1 m
- AUX Data Cable: Sync, HD26 to 3 X DB9, 1 m
- AUX Data Cable: Async, AUX HD26 to AUX HD26, 1 m
- AUX Data Cable: Sync, AUX HD26 to AUX HD26, 1 m
- AUX Alarm I/O Cable: HD15 to Wirewrap, 2 m or 5 m
VOLUME III, CHAPTER 2, ODU INSTALLATION
Installing the Antenna
Before going to the antenna installation site, check that you have the required install-
ation tools as recommended by the antenna manufacturer.
Also make sure you have the data needed to locate the antenna on the tower, and to
set its polarization and initial pointing.
l The parabolic antennas available from Aviat Networks for the 5.8 GHz
unlicensed band are FCC approved and have a maximum gain not exceeding
45.9 dBi.
l They include a collar for direct-mounting the ODU.
l The collar includes a polarization rotator.
l The antenna mount is designed for installation on industry-standard 115 mm
OD (4.5 inch) pipe-mounts.
l All antennas are supplied with an installation guide.
l For information more information contact Aviat Networks or your supplier.
Refer to the Aviat Networks Best Practices Guide for supporting data.
44 AVIAT NETWORKS