User's Manual

µLink System Manual 862-01545
Page 54 Issue 1b
Indoor Unit: Status
This screen (see Figure 16) allows you to monitor the
network’s performance. It provides the following data:
• Status of the Near and Far site Fail, Site and
Service alarms.
• Status of the Rx Sync, Tx Sync, LOS and AIS
alarm LEDs.
• Transceiver Error Counts for Code Violation,
CRC4 and FAS.
• Bit Error Rate and Total Blocks of payload data
transmitted.
If you want to clear the LEDs, simply click on the
<Clear LEDs> button.
If you want to clear the Error Counts, simply click on
the <Clear Counts> button.
You can see more details of the Fail, Site and Service
alarms by clicking on the respective highlit button.
This initiates the selected site IU Detailed alarm screens
(see Figure 17, Figure 18 or Figure 19 respectively).
Figure 16. Indoor Unit: Typical Status Screen.