User's Manual

µLink System Manual 862-01545
Page 46 Issue 1b
Software and
Hardware
(supplied by
Tellumat)
The software is the operator interface to the operation
and control of the µLink System. It allows you to
perform tasks such as; system configuration,
controlling system parameters and accessing on-line
help.
It is supplied by Tellumat on one 1.44 Mbyte, 3.5 inch
stiffy diskette. It is supplied as executable code,
supported with installation and other supplementary
files.
In addition to the software, Tellumat also supplies an
RS232 interconnection cable for use between the IU
and the PC interface. Refer to Appendix A at the end
of Chapter 2 in this manual for pin details of this cable
interface (Monitor connector).
Setting-up
Follow these steps to set up the µLink Management
Information System for use with the µLink:
Step Action
1. Connect the supplied interface cable between
the RS-232 port on the rear of the computer,
to the Monitor connector on the front panel of
the Indoor Unit.
2. Switch the computer On.
3. Run the Windows operating system.
4. Insert the application Software disk into the
appropriate disk drive (A or B).
5. In Windows 95, access the Control Panel and
select the Add/Remove Programs. From the
Install/Uninstall folder, select the Install
button.