User's Manual

µLink System Manual 862-01545
Page 24 Issue 1b
Installation
Overview
Installation of the µLink is described under the
following four main headings:
a. Installing the Outdoor Unit (OU) and Integral
Antenna.
b. Installing the Indoor Unit (IU).
c. Installing the IU/OU Interconnection Cable.
d. System Commissioning.
To supplement the installation procedure, the
following appendix is provided at the end of this
chapter:
• Appendix A provides connector pin details for the
external connectors of the IU and OUs.
Antenna
Installation
Follow these general steps to install the Antenna.
Refer to the Antenna Manufacturer’s installation
instructions for specific types of antennas.
Step Action
1. Secure the C-shaped mounting bracket to the
Antenna using the two securing screws and
bolts (see Figure 6).
2. Position the antenna in the required position
on the pole. Note the orientation of the
antenna.
3. Secure the antenna to the pole by tightening
the mounting bracket securing nuts (two nuts
on either end of the pole clamp).
CAUTION
ENSURE THAT THE POLE IS EARTHED FOR
LIGHTNING PROTECTION ACCORDING TO
STANDARD LOCAL PRACTICES.