User's Manual

µLink System Manual 862-01545
Page 52 Issue 1b
Indoor Unit:
Configuration
This screen allows you configure the following items
(see Figure 14):
• Wayside Port
• Payload Data Interface Port
• Bit Error Rate Thresholds
To configure the ports, click on the required
parameter(s).
Configure the BER thresholds as required. Payload is
from the user equipment to the IU Payload Data
connector and RF Link is from Antenna to Antenna.
Note that the thresholds must be entered in scientific
notation, eg. 1.0E-6. If the Minor or Major thresholds
are exceeded, it will trigger a Service Alarm fault. If
the Critical threshold is exceeded, it will trigger a Fail
alarm.
When finished, click on the <Apply> button. This
transmits the parameters to the selected IU.
Figure 14. Indoor Unit: Typical Configuration Screen.