User's Manual

ECLIPSE INSTALLATION MANUAL
Chapter 1. Introduction to
Eclipse Installation
This section provides a list of recommended installation tools and materials, and a
procedure for unpacking and checking the equipment.
Eclipse has been tested for and meets EMC Directive
89/336/EEC. The equipment was tested using scr eened cable;
if any other type of cable is used, it may violate compliance.
CAUTION: Eclipse is a Class A product. In a domestic environment it
may cause radio interference: be prepared to resolve this. Eclipse
equipment is intended to be used exclusively in telecommunications
centers.
WARNING: You must compl y with the r elevant heal th
and safety practices when wor ki ng on or around
Ecli pse radi o equi pment. Refer to Health and Safety on
page 5
Installation Overview
The following list provides a basic guide, in order, of an Eclipse hardware instal-
lation process.
Hardware installation typically proceeds as follows:
1. Pre-Installation
l Unpack equipment - see Unpacking on page 48
l Verify system configuration
l Check basic components
l Check kits and accessories
2. Installation
l Antenna - refer to the antenna manufacturer's installation instructions
l Waveguide and waveguide pressurization equipment - refer to manufacturer's
installation instructions
l IRU 600 - see IRU 600 Installation on page 49
l INU chassis - see INU and INUe Installation on page 59
l INU plug-in cards - see Plug-in Installation on page 74
l Traffic and NMS cables - as required
260-668066-001 OCTOBER 2012 47