User's Manual
Table Of Contents
- Eclipse Installation Manual for 5.8 GHz Unlicensed Band Rev.003
- Copyright & Terms of Use
- Aviat Networks Support
- Eclipse Product Compliance Notes
- Contents
- Volume I: Introduction and Safety
- Volume II: System Overview
- Volume III: Installation
- Chapter 1. Introduction to Eclipse Installation
- Chapter 2. IRU 600 Installation
- Chapter 3. INU and INUe Installation
- INU/INUe Overview
- Installation Requirements
- Installation Procedure
- Plug-in Installation
- INU/INUe Cable Assemblies
- DAC Trib Connectors and Cables
- NMS Connectors and Cables
- NMS 10/100Base-T Connector
- Maintenance V.24 Connector
- Auxiliary and Alarm Connectors and Cables
- AUX Data Cable: Async, HD26 to Wirewrap, 2 m
- AUX Data Cable: Sync, HD26 to Wirewrap, 2 m
- AUX Data Cable: Async, HD26 to 3 X DB9, 1 m
- AUX Data Cable: Sync, HD26 to 3 X DB9, 1 m
- AUX Data Cable: Async, AUX HD26 to AUX HD26, 1 m
- AUX Data Cable: Sync, AUX HD26 to AUX HD26, 1 m
- AUX Alarm I/O Cable: HD15 to Wirewrap, 2 m or 5 m
ECLIPSE INSTALLATION MANUAL
RF Exposure
To ensure compliance with the FCC RF exposure requirements, a minimum distance
of 20 meters must be maintained between the antenna and any persons whilst the
unit is operational. This calculation is based on the maximum conducted power and
maximum antenna gain.
l Eclipse with IRU600, 5.8 GHz, has been tested and certified for use with a
parabolic antenna with a maximum gain of 45.9 dBi or a flat panel antenna
with a maximum gain of 28 dBi. Higher gain antennas must not be used.
l The transmit output power on the IRU 600 has been limited to a maximum of
29 dBm at the antenna port to ensure compliance with the 1W power limit in
FCC CFR 47, Part 15.247.
260-668066-001 OCTOBER 2012 11