User's Manual

260-668066-003 Rev 001 August 2010 4-1
Chapter 4. Introduction to
Eclipse Installation
This section introduces Eclipse installation procedures, from unpacking and checking
the equipment to completion of the physical installation.
Eclipse has been tested for and meets EMC Directive 2004/108/EC. The
equipment was tested using screened cable; if any other type of cable is
used, it may violate compliance.
Eclipse is a Class A product. In a domestic environment it may
cause radio interference: be prepared to resolve this. Eclipse
equipment is intended to be used exclusively in
telecommunications centers.
You must comply with the relevant health and safety practices when
working on or around Eclipse radio equipment. Refer to Health and Safety.
Before Going On Site
Installation Tools and Materials
Ensure you have the following tools and material before going to site. These items that
be sourced or supplied by the installer.
Table 4-1. Required Tools and Material
Equipment Tool/Material Description
Antenna As required by the
manufacturer
Aviat Networks offers antennas from several suppliers. Refer
to the manufacturer’s data supplied with each antenna for
required and recommended installation tools and equipment.
Antennas must be FCC approved for 5.8 GHz unlicensed band
operation.