User Manual

MDR2400/5800-SR, Orion2410/5810-SRi and Orion 5825-SR
862-01881 Issue 12c Page 116
Setup for Full Duplex mode on the MDR: Max Transfer Rate
Follow the steps outlined below to setup the MDR radio in Full Duplex mode:
• Upload the radio Firmware by following the aforementioned procedure. Full
duplex Ethernet operation is supported from version 2 of the firmware.
• Setup default configuration of the radio to the required configuration. Refer to
Section 2.3.4 for a description of the different default configurations.
• Ensure that the PCB revision of the DIU is issue_2_mod_a(3) by reading the
following MIB element: 1.3.6.1.4.1.1316.1.1.1.2.4.15
mdrmteIndoorUnitPCBrevision. If the PCB revision is issue_2(2) the radio
hardware does not support Full Duplex Ethernet mode.
• Disable all tributary channels to make the maximum user bandwidth available for
Ethernet traffic.
• Enable Full Duplex mode via the MIB using element: 1.3.6.1.4.1.1316.1.1.1.4.16
mdrmteEthernetFullDuplex.
• Set the data rate to T1 if required using MIB element: 1.3.6.1.4.1.1316.1.1.1.2.1.1
mdrmteDataRate.