User Manual

MDR2400/5800-SR, Orion2410/5810-SRi and Orion 5825-SR

862-01881 Issue 12c Page 30

4.1 Customer Furnished Tools and Equipment

The following table lists tools and equipment required to install the MDR2400-SR,

MDR5800-SR, Orion2410-SRi, Orion5810-SRi and the Orion 5825-SR system.

General, DIU-to-RFU Interconnect

• Cable cutting and stripping tools.

• Ground lug crimp tools.

• 3 mm flat screwdriver - DIU to RFU power cable.

• RJ45 crimp tool - DIU to RFU data cable.

• Soldering iron.

• Ground cable or strap rated at 45A with 5 mm ground lug for grounding the Indoor

and RF Units.

• Cable ties, used to secure the cables to the mast at regular intervals.

DIU

• Pozi #2 screwdriver - DIU mounting in a 19" rack and the ground lug.

• 7mm Spanner – Attaching the earth cable to the DIU.

• 2.5mm Allen key - To change the position of the DIU mounting brackets.

• DC power supply cable: minimum 2.5 mm square conductor, rated for 10 A. For

connection between the power supply and the Digital Indoor Unit DC connector on

the rear panel. (The DC connector is on the front panel of the Orion DIU.)

• DIU ground lug: 10-4 (10 square mm for wire and hole big enough for M4 thread)

Outdoor RFU

• 13 mm wrench / spanner – used for attachment of RFU to mounting bracket and

mounting bracket to pole. Also used to close RFU with hinge type connection box.

• 2.5 mm Allen key - used to tighten RFU connection box cover fasteners.

• RFU ground lug: 10-8 (10 square mm for wire and hole big enough for M8 thread)

• Multimeter (recommended) to measure RSSI at RFU during antenna panning.

The RSSI level may also be read from the NMS / GUI via laptop connection to the

DIU, indoors