User's Manual

MDR2400-SR, MDR5800-SR and Orion 5825-SR

Issue 10 Page 31

s. Installing the Indoor Unit (paragraph 4.2, page 32)

t. Installing the Outdoor Unit and Antenna (paragraph 4.3, page 38)

u. Installing the interconnection cables (paragraph 4.4, page 38)

4.1 Customer Furnished Tools and Equipment

The following table lists tools and equipment required to install the MDR2400-SR, the

MDR5800-SR and the Orion 5825-SR system.

General, IU-to-OU Interconnect

• Cable cutting and stripping tools.

• Ground lug crimp tools.

• 3 mm flat screwdriver - IU to OU power cable.

• RJ45 crimp tool - IU to OU data cable.

• Soldering iron.

v. Ground cable or strap rated at 45A with 5 mm ground lug for grounding the Indoor

and Outdoor Units.

w. Cable ties, used to secure the cables to the mast at regular intervals.

• Pozi #2 screwdriver - IU mounting in a 19" rack and the ground lug.

• 7mm Spanner – Attaching the earth cable to the IU.

• 2.5mm Allen key - To change the position of the IU mounting

brackets.

x. DC power supply cable: minimum 2.5 mm square conductor, rated for 10 A. For

connection between the power supply and the Indoor Unit DC connector on the

rear panel. (The DC connector is on the front panel of the Orion IU.)

• IU ground lug: 10-4 (10 square mm for wire and hole big enough for

M4 thread)

• 13 mm wrench / spanner – used for attachment of OU to mounting

bracket and mounting bracket to pole. Also used to close OU with

hinge type connection box.

• 2.5 mm Allen key - used to tighten OU connection box cover

fasteners.

• OU ground lug: 10-8 (10 square mm for wire and hole big enough for M8 thread)

• Multimeter (recommended) to measure RSSI at OU during antenna panning. The RSSI level

may also be read from the NMS / GUI via laptop connection to the IU, indoors

Please refer to paragraphs 4.3.1 and 8.5.10 for details on the RF and data cables,

which are also customer furnished equipment.