User manual

www.grisoft.com
Copyright (c) 1992-2006 GRISOFT, s.r.o. All rights reserved.
AVG Linux Email Server / User Manual
12
o Time::HiRes (Time-HiRes-x.xx, use 1.49 or later, older versions can
cause problems)
o Unix::Syslog (Unix-Syslog-x.xxx)
o BerkeleyDB with bdb library 3.2 or later (4.2 or later preferred)
All of these modules are available for free at
http://www.cpan.org/. The usual
way of installing a new Perl module consists of unpacking the downloaded file,
switching into the unpacked directory, and running the following sequence of
commands as root:
# perl Makefile.PL
...
# make test
...
# make install
Make sure
AVG for Linux E-mail Server is installed and operational before
starting the
AMaViS installation.
b)
Installation
To install
AMaViS from the source code, unpack the selected downloaded
package (the
amavis package is given in the following example):
$ tar -xvzf amavis-{version}.tar.gz
Switch to the unpacked directory. It is recommended to read the detailed
instructions in the INSTALL and/or README file located in this directory. The
easiest way of performing the installation is to run the following sequence of
commands as root (although the installation steps may slightly differ
according to the particular
AMaViS package):
# ./configure
...
# make
...
# make install
...
c)
Configuration
Most configuration options should have been resolved by automatic
configuration. Of course, it is also possible to perform manual changes to the
generated
amavis script (note that the exact name of the script may depend
on which
AMaViS package you have decided to install). If you switch to a