User manual

Table Of Contents

This dialog is meant to facilitate your work and to accelerate installation process. If your

access rights are not sufficient for AVG installation on the remote station, you will be asked

to enter a username that has administrator privileges (a username that is member of an

administrator's group). If there is no common administrator account for all stations (with the

same login name and password) you will be asked separately for every station.

This dialog allows you to modify a list of accounts that will be used during remote installation;

this way you will avoid entering multiple credentials. You can add accounts to the list by

clicking the Add button (or delete them using the Remove button).

Export selected stations list - exports selected stations into a .csv file.

Install selected stations - displays Remote Network Installation dialog which will guide you

through the network installation process itself.

Warning: AVG remote installation can be performed only on stations with the supported operating

system installed. See the full list of supported operating systems in the Operating Systems

Supported chapter. Also, you need to know a logon username with administrator privileges.

You may also need to review the Network Requirements chapter.

You can choose basic or advanced remote network installation:

Basic remote network installation - recommended for beginners.

Advanced remote network installation - recommended for advanced users.

Before you begin with the installation of the remote stations, you may want to review the following

chapters:

Recommendations for Components

Network Requirements

Note: This chapter describes the basic setup of Network Installer available from the AVG Admin

Console. If you prefer to configure more details, proceed to the Advanced Remote Network

Installation chapter.

This wizard allows you to remotely install AVG on stations in few easy steps.