User guide

Apply Alarm Sets
30
3. Use the Ignore additional alarms for <N> <periods> to specify the number of minutes to ignore the
same set of alert conditions. Set to 0 to trigger an alarm each time an alert condition occurs.
4. Click Save to save the alarm set.
To Delete an Alarm Set
1. Select an alarm set from the Select Profile drop-down list.
2. Click Delete to delete the alarm set.
Ignore additional alarms <N> <periods>
Specify the number of periods you want the same type of alarm to be ignored after the first alarm is
triggered.
Alarm Conditions
Check any of the following types of alarm conditions to include it in a Endpoint Security alarm set.
 Threat Detected and Not Healed - A threat has been added to the Current Threats tab of the View
Threats (page 11) page that could not be automatically healed
 Protection Disabled - Security protection has been disabled.
 Definition Updated - Security protection has been updated with the latest version of Endpoint
Security.
 Scheduled Scan Completed - A security protection scan has been completed.
 Reboot Required - A reboot is required.
 Protection Enabled - Security protection has been enabled.
 Service Error - The Endpoint Security service has stopped.
 Definition Not Updated in <N> Days - Security protection has not been updated for the specified
number of days.
 Scheduled Scan Did Not Complete - A scheduled security protection scan did not complete.
 AVG Removed by User - A machine user has uninstalled the AVG client from the managed machine.
Apply Alarm Sets
Security > Apply Alarm Sets
The Apply Alarm Sets page creates alerts in response to security protection alert conditions defined
using Define Alarm Sets (page 29). The alarms sets are applied to selected machine IDs licensed to
use Endpoint Security.
The list of machine IDs you can select depends on the machine ID / group ID filter and the scope you
are using. To display on this page, machine IDs must have the Endpoint Security client software
installed on the managed machine using the Security > Installation (page 15) page.
The page provides you with four actions:
 Apply - Apply a selected alarm set to selected machine IDs.
 Remove - Remove a selected alarm set from selected machine IDs.
 Remove All - Remove all alarm sets assigned to selected machine IDs.
To Create an Alert
1. Check any of these checkboxes to perform their corresponding actions when an alert condition is
encountered:
 Create Alarm
 Create Ticket
 Run Script