Specifications

Getting Started Manual
922157-00 Rev A
235
Safety Compliance
EC DECLARATION OF CONFORMITY – LOW VOLTAGE
The oscilloscope meets intent of EC Directive 2006/95/EC for Product
Safety. Compliance was demonstrated to the following specifications as
listed in the Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 2-030: Particular
requirements for testing and measuring circuits
The design of the instrument has been verified to conform to the following
limits put forth by these standards:
 Measurement Category II: equipment intended to be supplied
from the building wiring with a nominal supply voltage up to 300V.
 Measurement Category 0: oscilloscope measurement terminals
that are not intended to be directly connected to the MAINS
supply.
 Pollution Degree 2: an operating environment where normally only
dry, non-conductive pollution occurs. Occasionally a temporary
conductivity that is caused by condensation must be expected.
This location is a typical office/home environment.
 Protection Class I: grounded equipment in which protection against
electric shock is achieved by Basic Insulation and a connection to
the protective ground conductor in the building wiring.
U.S. NATIONALLY RECOGNIZED AGENCY CERTIFICATION
The oscilloscope has been certified by Underwriters Laboratories (UL) to
conform to the following safety standard and bears UL Listing Mark:
UL 61010-1 Second Edition – Safety standard for electrical measuring and
test equipment.