User manual

these stations only. Otherwise installation will be performed on all listed stations.

If your access rights are not sufficient for AVG Agent service installation on the

remote station, you will be asked for the domain administrator’s login/password during

installation.

Enter a username that has administrator privileges (a username that is member of the

administrator's group). Confirm by clicking OK.

If there is no common administrator account for all stations (with the same login name

and password) you will be asked separately for every station.

Pressing the Cancel button will cause the current station installation to be skipped,

and the wizard will continue installation on the next station in the list.

AVG should be then transferred to the station and installed. You will see on each line,

if the installation was successful (however it may take some time to process).

Once all your stations receive the installation files and the installation has begun on

them, you will be able to leave this dialog by clicking the Next button.

Note: You can later review recently installed stations from the AVG Admin Console

either in the Stations/New stations or in the group chosen during the Remote

administration settings dialog.

To list recently installed stations that remain in an incorrect state (because of some

remote installation failure), navigate to the Stations/Non-compliant stations.

Also, on Windows XP SP2 and higher with Windows Firewall enabled, the AVG Agent

once installed will automatically create a communication rule and allow its execution

and network communication.