User manual

104
AVG 8.5 Free © 2009 Copyright AVG Technologies CZ, s.r.o. All rights reserved.
 Schedule running - specify the intervals for the scheduled scan launch.

Run every - run the scan every 'n' number of hours. E.g. every 4 hours.

Run at specific time - select Every day, or select a specific day of the
week, and specify what time of day the scan should start.

Action based - run the scan on computer startup.
Note: More comprehensive options are available in full versions of AVG.
 Advanced schedule options

Run on computer startup if task has been missed - if the scan
cannot run at the scheduled time/interval, then it will run the next time
the computer restarts.

Run even if computer is in low power mode - this option applies to
battery powered computers such as notebooks. The default action is for
AVG to postpone scanning when the computer's power resources are
low.
 Task settings - in the section you can uncheck the Enable this task item to
simply deactivate the scheduled test. Not recommended.
Control buttons of the Settings for scheduled scan dialog
 Save - saves all changes you have performed on this tab or on any other tab
of this dialog and switches back to the AVG scanning interface default dialog.
Therefore if you wish to configure the test parameters on all tabs, press the
button to save them only after you have specified all your requirements.
 Cancel - cancels any changes you have performed on this tab or on any other
tab of this dialog and switches back to the AVG scanning interface default
dialog.