Instruction manual

4-22 Operator’s Handbook
Verifier
The verifier scans and checks the quality of bar codes as they are printed.
The optional verifier must be purchased separately. The verifier scans
parallel bar codes; it can not scan serial bar codes or read the RFID data
programmed into the label.
The verifier must be enabled and set up before you can scan bar codes. For
set up procedures, refer to your verifier's Operating Instructions available on
our Web site.
To enable the verifier, from the Main Menu, select Setup, then Verifier.
Then follow these steps.
1. Press » or ¼ until you see
VERIFIER
» State
2. Press Enter/Pause. The current setting is displayed, for example:
VERIFIER
Disabled ¼
3. Press » or ¼ to see the other option. After you display the option you
want, press Enter/Pause. Press Escape/Clear until you see the Main
Menu.