Instruction manual

Setting Supply Options 4-17
Error Action
You can change how the printer responds to a bad label. The choices
include normal and overstrike/continue one to five consecutive bad labels.
The overstrike pattern is created to prevent someone from using the label.
Selecting overstrike and continue 1x-5x sets the number of times the printer
prints an overstrike pattern on consecutively bad labels before generating
an error. The user must clear the error before operation can continue.
Consider this scenario when the error action is set to
overstrike/continue 3x:
If the printer errors on the first label, an overstrike pattern is printed, but the
printer attempts to reprint the image up to three times. If the third
consecutive label also generates an error, an overstrike pattern is printed;
however, the printer stops and the error message is displayed. The operator
must resolve the error condition before printing continues.
In the above example, if the third label did NOT generate an error,
♦ the batch image is printed
♦ the consecutive error counter is reset
♦ the printer continues processing the batch.
Error Action Modes
Normal (default)
The printer errors and the condition causing the
error is displayed. The error must be cleared
before operation can continue. An operator must
press Escape/Clear to clear the error and continue
printing. No overstrike pattern is printed.
Overstrike/Continue 1x
Overstrike/Continue 2x
Overstrike/Continue 3x
Overstrike/Continue 4x
Overstrike/Continue 5x
The printer prints an overstrike pattern on one,
two, three, four, or five consecutive labels and
stops printing after the selected number of
overstrike patterns have been printed. An operator
must press Escape/Clear to clear the error and
continue printing.
Note: The printer does not recalibrate (feed a blank label) after any RFID
error.