Instruction manual

4-12 Operator’s Handbook
Cut Position
This function adjusts where the tag is cut. The printer adjusts the cut
position according to the black marks on the supply. You may need to adjust
for aperture supplies. Increase to move the cut up; decrease to move the
cut down.
To change the setting, from the Main Menu, select Setup, Supply, then
Positioning. Then, follow these steps.
1. Press » or ¼ until you see
POSITIONING
» Cut Pos ¼
2. Press Enter/Pause. The current setting is displayed, for example:
Enter knife adj
[-300/300]: +0
3. Press » or ¼ to change the cut position. Pressing » decreases the
value (moves the cut down); ¼ increases it (moves the cut up).
4. Press Enter/Pause when the number you need appears. Press
Escape/Clear until you see the Main Menu.
Dispense Position
This function adjusts the stopping point of the label.
To change the setting, from the Main Menu, select Setup, Supply, then
Positioning. Follow these steps.
1. Press » or ¼ until you see
POSITIONING
» Dispense Pos ¼
2. Press Enter/Pause.
DISPENSE POS
[50/200]: +65
3. Press » or ¼ to change the dispense position. Pressing » decreases
the value; ¼ increases it.
4. Press Enter/Pause when the number you need appears. Press
Escape/Clear until you see the Main menu.