Instruction manual

Setting Supply Options 4-7
Backfeed
Backfeed works by advancing each printed label to the desired dispense
position. Once that label is removed, the next label to be printed is backed
up underneath the printhead. In continuous mode, only the last label in the
batch is advanced to the dispense position. Extended backfeed is available
on this printer with a knife installed. Extended backfeed feeds a tag far
enough out to be cut and backfeeds the next tag to the printhead line.
Note: We recommend using 0.5-inch gap supplies in peel mode when
backfeed is disabled.
To change the setting, from the Main Menu, select Setup, then Supply.
Then, follow these steps.
1. Press » or ¼ until you see
SUPPLY
» Backfeed ¼
2. Press Enter/Pause to set the backfeed option. The current setting is
displayed, for example:
BACKFEED
» On ¼
3. Press » or ¼ to see the other options. After you display the option you
want, press Enter/Pause. Press Escape/Clear until you see the Main
Menu.