Instruction manual

4. Clean the platen roller when you see significant adhesive build-up or a
label is wrapped around the platen roller. Use a dry, soft-bristle brush,
such as a toothbrush, to clean either the standard (black) or linerless
(red/orange textured) platen roller. If the brush does not remove all the
adhesive
♦ Use isopropyl alcohol ONLY on the standard (black) platen roller.
Moisten a cotton swab with isopropyl alcohol and run the cotton swab
across the platen roller. Turn the platen roller with your finger to make
sure the platen roller is clean all the way around.
After cleaning, feed several inches of supply through without printing to
remove any remaining isopropyl alcohol.
♦ Call Service to clean the linerless (red/orange textured) platen roller.
Note: Do not use alcohol or solvents on linerless (red/orange textured)
platen rollers.
5. Moisten a cotton swab with isopropyl alcohol. Rub the cotton swab
across the peel bar and remove any build-up.
6. Moisten another cotton swab with isopropyl alcohol. Rub the cotton swab
across the printhead and remove any build-up. You may need to use a
printhead CLEAN-STRIP if the printhead is extremely dirty or you see
streaks on the supply.
Printhead
Care & Maintenance 9-3