Instruction manual

Setting the Speed
You can change the print speed for bar codes or graphics. If you select
"default" for speed, formats with serial bar codes automatically print at 2.5
ips and formats with parallel bar codes print at 6.0 ips.
Note: If you change the speed, you must resend your formats or turn the
printer off and back on before the change takes effect.
To change the setting, from the Main Menu, select Setup, then Supply.
Then, follow these steps.
1. Press » or ¼ until you see
SUPPLY
» Speed ¼
2. Press Enter/Pause to set the speed option. The current setting is
displayed, for example:
SPEED
» Default
3. Press » or ¼ to see the other options. After you display the option you
want, press Enter/Pause. Press Escape/Clear until you see the Main
Menu.
Setting Supply Options 4-5