Instruction manual

9. Close the exit cover.
10. Load supplies by following the label loading procedures. You may notice
a different color and texture on the platen roller. Linerless supplies do
not stick to the textured platen roller.
11. Close the printhead assembly and the cover.
12. Turn on the printer.
13. Verify the alignment of the platen roller with the peel bar or shelf. Press
Feed/Cut to position the supply under the printhead.
14. Once linerless supply is loaded, slightly loosen the supply roll holders
from the edges of the supply roll. This allows linerless supplies to track
better.
Adjusting the Wide/Narrow Knobs
You may need to adjust the two wide/narrow knobs according to the width of
your supply. For supply that is more than two inches, adjust the knobs to
the wide setting. For supply that is two inches or less, adjust the knobs to
the narrow setting. For linerless supply, use the narrow setting (knobs are
up). For string tag supply, use the wide setting (knobs are down).
You must adjust both of the knobs to the same position.
If you experience ribbon
smudging in cold, dry
environments, adjust the
wide/narrow knobs to the
wide setting.
For wide supplies, push
down and turn the
wide/narrow knobs
clockwise with a
screwdriver.
For narrow supplies, turn the wide/narrow knobs counter-clockwise with a
screwdriver until it pops back up.
Note: The adjustment is shown in the wide position.
Loading Supplies 2-13