Instruction manual

Printing Method: Thermal Transfer (ribbon) or Thermal Direct
Print Speed: 2.5 ips (64 mm) default for all serial bar codes, 4.0 ips
(102 mm) or 6.0 ips (152 mm) default for parallel bar
codes
Maximum Print 4.0 inches x 16.0 inches (102 mm x 406 mm)
Area:
Supplies
For high temperature or high humidity environments, contact us for supply
recommendations. Continuous (non-indexed) supply does not have
perforations or black marks and must be used in continuous mode. Aperture
supplies are tags or labels with holes (or openings) in them. The supply is
sensed using the holes. The holes can be only on the edge or in the center
of the supply.
Supply Types: Thermal Transfer or Direct
Supply Widths: 0.75 inches (19 mm) minimum
4.25 inches (108 mm) maximum
Supply Lengths: 0.32 inch (8 mm) minimum
17.5 inches (445 mm) maximum
Total Thickness: 7to 12 mils
Linerless Supplies
For Supply Width
greater than or equal to
Use Supply Length
1.5 inches (38 mm) 1.5 inches to 16 inches (38 mm to 406 mm)
2.0 inches (51 mm) 1.5 inches to 16 inches (38 mm to 406 mm)
3.0 inches (76 mm) 2.0 inches to 16 inches (51 mm to 406 mm)
4.0 inches (102 mm) 2.5 inches to 16 inches (64 mm to 406 mm)
Note: A 0.50 inch non-print zone exists on the leading edge (beginning) of
all labels.
A-2 Operator's Handbook