Service manual

M09416
®
TTXLI
®
Thermal Transfer Printer
40
4. GAP AND BLACK MARK SENSOR SELECTION
Gap Sensor selection
 Default setting. No extra action necessary.
 If you want to change sensor type from black mark sensor to gap sensor,
please do printer initialization (refer to Initialization section).
Black Mark Sensor
 Start Nice Label SE software.
 Set label side in the software and select black mark sensor as sensor type.
 Install label media with black mark or hole for registration.
 Print one label to switch sensor from gap to black mark sensor.
Remember; always do sensor calibration after sensor selection (refer to
Gap and
Black Mark Sensor Calibration section).
5. BIOS Update
If printer BIOS update is required, please do the following steps.
Update the BIOS file and reset the printer.
Update File
1. Make sure the printer is at ready status and the LED is solid green.
2. Copy the BIOS file to printer parallel port by the following command at
MS-DOS prompt mode.
C:\>COPY M09416TTXL.NEW /B LPT1 <Enter>
3. During BIOS updating process, the LED will blink red and orange alternately.
When BIOS update is completed, printer will reset automatically and LED will
become solid green.