Service manual

M09416

TTXLI

Thermal Transfer Printer

7. Close the top cover by lifting up the top cover support and

close the top cover

slowly.

Complete label installation in cutter mode

3. Power on Utilities

There are six power-on utilities to set up and test printer hardware. These utilities are

activated by pressing FEED button and by turning on the printer power simultaneously.

The utilities are listed as below:

1. Ribbon sensor calibrationGap/black mark sensor calibration

2. Gap/black mark sensor calibrationSelf-test and dump mode

3. Printer initialization

4. Black mark sensor calibration

5. Gap sensor calibration

3.1 Ribbon and Gap/Black Mark Sensor Calibration

Gap/black mark sensor sensitivity should be calibrated at the following conditions:

1. A brand new printer

2. Change label stock.

3. Printer initialization.

Please follow the steps below to calibrate the ribbon and gap/black sensor.