User`s manual

Model 1310 Truck Scale In/Out Application User’s Manual

SETUP soft key Brings up a display similar to this example:

This display shows you the configuration of the

SensorComm system. In this example the system has

two SensorComm j-boxes with a total of eight weight

sensors. Press any key and the following is displayed:

This screen lets you scroll through all the sensors using

the PREV and NEXT soft keys. Information displayed

for each sensor is programmed capacity, output in mV/

V, serial number and span factor.

VALS soft key Brings up a display similar to this example:

This display shows you the stored cornering values for

each sensor attached to a SensorComm j-box. Press

any key to see the next SensorComm values if there is

another attached. Returns to VERS-SETUP-VALS soft

key set after viewing the last set of values.

Press this key to view the current output of each weight sensor in raw

counts or mV/V. You will see a display similar to this example:

This display shows you the current output in raw counts for each sensor

attached to SensorComm #1. Press the PREV or NEXT soft key to move

between multiple SensorComm j-box displays.

If you press the CNTS soft key, you will see a display similar to this ex-

ample:

This display shows you the current output in mV/V for each sensor attached

to SensorComm #1. Press the PREV or NEXT soft key to move between

multiple SensorComm j-box displays.

OUTPT Soft Key

Press the ESC key to back out

of most displays and return to

the previous display.

Press DONE to return to

the previous level display.

Press DONE to return to

the previous level display.