User`s manual

19
Model 1310 Truck Scale In/Out Application User’s Manual
These softkeys appear:
KEYPAD This test lets you check each front panel key for proper opera-
tion. Follow the instructions on the display.
SCALE Press this soft key to view weight sensor outputs. Disabled
when SensorComm active.
SERIAL Use this to test your ports. Select Port #1 through 4 then short
the TX and RX on the selected port. The display will change
from NO LOOP to LOOP indicating the port is good. Jumper
RTS to CTS to test the handshake lines.
MORE Accesses the following keys:
INPUT Allows you to Activate/Deactivate any input setpoint
device such as a switch or contact closure remotely and
monitor it with this menu.
OUTPT Allows you to Activate/Deactivate any output setpoints
to verify correct hardware operation during installation or
for troubleshooting purposes.
DISP This test continuously cycles the display through a test
pattern.
SCOMM Present only if SensorComm
TM
is active. It accesses the
SensorComm diagnostics which are explained the
following section, SCOMM Soft Key.
MORE Accesses the following keys:
NET This diagnostic will only appear if a network option card
is installed. Follow the instructions on the display. For
more information reference the 1310 Network Installa-
tion Guide PN29806-0013.
Inputs and outputs have to be
defined in the WT-BASIC
program for them to work.