User`s manual

WP-233 Printer User’s Manual16
Load Defaults
Baud Rate
Data Bits
With the printer in the setup menu and with
CONFIGURE . . . [NEXT/OK] as the last item
printed, press OK (right side) to access the
configure menu. The following is printed:
LOAD DEFAULTS gives you the opportunity to
reset the printer to all default settings (shown
below).
Choose OK to do this or NEXT to go to the next
parameter. The following is printed:
Baud rate is the next parameter you can set in the
configure menu. The complete list of parameters
and their possible values is shown below.
The sample list above shows the current baud rate
is 1200. To accept this, press OK (right side) or
view the next baud rate value by pressing NEXT
(left side). Press OK when the baud rate you want
is displayed.
Choose from these baud rates;
300, 600, 1200, 2400, 4800, 9600, or 19200
DATA BITS is the next parameter. Choose the
data bit value the same way baud rate was
chosen. Choices are 7 or 8 data bits.