Instruction manual

Model 1040/XL User Instructions 43
9.4 Pen Unloading
9.4 Pen Unloading
The Model 1040 can keep track of amounts unloaded to 100 different pens. Make sure
all pens have been tagged with customized pen names as described in Editing Pen
Descriptions, otherwise pen names will have default names, PEN.001, PEN.002, etc.
1. Now with mixer full of a batched amount, and properly mixed, select an unload
pen number…
Pen number is shown
2. Press the PEN key…
Pen description is shown.
3. Press the LOAD/UNLOAD key…
Current unload amount is displayed.
If you need to enter or change the total amount to be unloaded to the
pen, enter the new amount and press SELECT. Otherwise proceed to
next step.
If attempting to enter a weight amount above the overcapacity
parameter the display will show CAN’T. Edit amount properly and then
press the SELECT key
4. Press the LOAD/UNLOAD to initiate the unloading to the pen…
The pen description is shown alternating on the display with entered
target amount. PEN-01>10000>PEN-01>9000, etc.
At this point the time needs to be saved in memory, for printing or
transfer to the TDM-40 or computer.
5. Begin unloading the amount displayed. As unloading takes place target also
goes down. Once the target has dropped by more than 25% only the target
value will remain displayed.
6. Stop unloading when the user notices on the display that the proper unload
target has been met…
Display shows 0.
7. Press MENU to accept amount unloaded and return to the Gross mode. If a
person wants to unload to another pen, then repeat steps 1-7.
At this point the actual amount unloaded to a pen is recorded.
8. If system has been set for autoprint, the following typical prints outs will have
been printed as they went through the process.
Press GROSS key to abort the loading process.