Instruction manual
40 Model 1040/XL User Instructions
Other Operations
2. Press the LOAD/UNLOAD key…
The following is displayed
a. WT.AMT
b. ADJ.AMT
c. HD.AMT
or
NOPRGM (This is displayed if that recipe is not programmed)
If you need to enter or change the total amount to be batched or the
number of head, enter the new amount and press SELECT. Otherwise
proceed to next step.
If you attempt to enter a weight amount above the capacity parameter or
a head count amount larger than 999, the display will show CAN’T. Edit
amount, and then press the SELECT key.
3. Press the LOAD/UNLOAD to initiate the loading of the first ingredient…
First ingredient description is shown alternating on display with target
amount. Example: Corn-1>3000>Corn-1>2800, etc.
At this point the time will be recorded as the time when the ingredient
was started to be saved and printed, or transferred to TDM-40, printer or
computer.
4. Begin loading the amount displayed…
As loading occurs the target weight goes down. Once the target has
dropped by more than 25% only the target value will remain displayed.
The display will no longer flash back and forth. (This is a programmable
parameter under 1040 MENU - NAME)
5. Stop loading the ingredient when you notice that the target weight has been
met…
Display shows 0.