Instruction manual

Model 1040/XL User Instructions 37
8.7 Using ID
3. Press the 3(GHI) key three times to display.. .
__ __ __ __ P I is shown.
4. Wait three seconds so the display has time to move the PI to the left and the
flashing cursor will appear to the right. You need to do this on this keying
sequence because I and G are on the same key. See section Entering
Alphanumeric Characters on page 11. Continue keying in characters until PIG-
01 is displayed.
5. Press SELECT…
PIG-01 is displayed, then press MENU and PEN.057, the next pen, is
displayed.
6. Repeat steps 2-5 until all pen names have been been properly edited and
press MENU to scroll through and view all pen descriptions.
To edit the Pen description, display the desired pen and use the keypad to
change the description. If you want to change back to the default description
simply access the desired pen name and press and hold the ZERO/CLEAR
key for 2 beeps (2 sec) PEN.CLR is displayed and then the next Pen
description is shown.
7. Press GROSS to return to Gross weighing mode.
8.7 Using ID
The Model 1040 has a generic six digit ID that can be used as an operator ID number.
This needs to be entered before doing any batching operations so the user is identified.
This ID will be printed on the reports or transferred to the TDM-40.
8.7.1 Entering an ID
To enter an ID number follow these steps:
1. From the Gross mode, enter the ID #, then press the ID key…
ID number is displayed for two seconds, then the display returns to the
Gross mode.
8.7.2 Viewing Current ID
1. From the Gross mode press the ID key…
Current ID is displayed
2. Press the GROSS key to return to the Gross mode.
This ID is active on all printouts until it is changed or cleared from the indicator