Instruction manual

34 Model 1040/XL User Instructions
Recipes and Pens
8.4 Creating A Recipe
Figure 8.1 shows the Recipe menu. You can refer to this menu as you go through the
process of creating recipes. The Model 1040 allows you to enter 100 recipes. You
choose the ingredients for a recipe from the list of ingredients entered under LIST in
the User menu. Once programmed, any recipe can be quickly recalled for batching
operations. Make sure you have the recipe entry mode set as you wish before
beginning. See Choose a Recipe Entry Mode on page 32.
Following are the steps to creating a recipe:
1. From the Gross mode there are two ways to get to a recipe. Either key in the
number of the recipe you want to program and press and hold the RECIPE key
for two beeps (two seconds)…
REC.XXX is displayed. XXX being the recipe number you keyed in.
OR
Press and hold the RECIPE key for two beeps (two seconds)…
REC.001 is displayed. This is the first of 100 recipes ready to be
programmed in a new indicator.
2. You can change the name of the recipe by using the keypad (See Entering
Alphanumeric Characters on page 11.) Once completed go to step 3.
OR
you can press SELECT to accept the default recipe name and go to step 3…
3. If you are entering a new recipe T 0 will be displayed. This is where the total
weight of ingredients is shown for a recipe.
4. Press the SELECT key…
ING is displayed.
5. Use the keypad to enter an ingredient number (X) from the LIST (1-100)…
X is displayed.
6. Now press SELECT…
The ingredient name is shown momentarily. (ex: CORN-1) and then
AMOUNT is shown.
7. Enter in amount of that ingredient…
Amount entered is shown
8. Now press SELECT…
ING is displayed
9. Repeat steps 5-7 until all ingredients are entered, then press SELECT…
TXXXXX is displayed. XXXXX is the total amount of ingredients.
100 ingredients standard. ING.001 to ING.100.