Instruction manual

26 Model 1040/XL User Instructions
User Menu
Example 1: Entering a recipe by net weight (WEIGHT>NORMAL mode or
WEIGHT>ADJUST mode)
Use this method when you have a recipe set up by weight for each
ingredient such as:
4000 lb batch size
Ingredient 1 = 1000 lb corn
Ingredient 2 = 1230 lb hay
Ingredient 3 = 1450 lb silage
Ingredient 4 = 320 lb alfafa
total = 4000 lb
When this recipe is selected in the future, you can enter the batch
size you want and all ingredient amounts will be proportioned
automatically.
Example 2: Entering a recipe by ingredient percentages (WEIGHT>NORMAL
mode or WEIGHT>ADJUST mode)
Use this method when you have a recipe set up by ingredient
percentages of a batch that adds up to 100, 1000, or 10000.
Enter the recipe by entering the percent of each individual
ingredient of the total batch so the total equals 100. Same
example as above would now be:
1. 2500 (represents 25.00% of corn)
2. 3075 (represents 30.75 % of hay)
3. 3625 (represents 36.25% of molass)
4. 800 (represents 8.00% of silage)
t 10000 (total % of all programmed ingredients)
(Depending on how many digits are entered ex; 25.03 % can be
entered as 25, 250,or 2503 depending on accuracy. You must
make total add up to 100, 1000, or 10000.)
Example 3: Entering a recipe based on head count of animals (HEAD.CT
MODE). See note below.
Use this when you want to mix a batch according to how many
animals can be fed. When you enter the recipe, the total weight
must add up to amount needed to feed 100 animals. When you
start a batch, type in the number of animals and the total batch
amount of the recipe will be automatically calculated.
To setup for standard weight mode (ENTRY>WEIGHT>NORMAL):
1. From the Gross mode, press and hold the MENU key for two beeps (2 sec),
then release…
LIST is displayed.
2. Press MENU repeatedly until ENTRY is displayed.
Head count is limited to 999 head.