Instruction manual

Model 1040/XL User Instructions 25
7.6 ENTRY
4. Press the MENU key toggle between the choices.
5a. Press SELECT when your choice is displayed…
If you select TIM.STD, TIMER is displayed.
If you select SLF.ADJ, CALIB is displayed. Use this to calibrate the
desired mixing speed. Press SELECT to enter calibration mode.
SET.SPD is shown. Make sure the mixer is at the target speed and press
SELECT. The display will show SPD.CAL until there is enough data to
calibrate. The display will show CALIB when done.
5b. Press the MENU key…
TOLER is displayed. Use this to set up the speed tolerance.
5c. Press SELECT…
Enter the tolerance (1-99%)
5d. Press SELECT…
Display shows TOLER.
6. Press the GROSS key repeatedly to return to the Gross weighing mode or
press the MENU key to move to the next menu item.
7.6 ENTRY
ENTRY stands for the recipe entry mode. The indicator can accept recipes in several
ways. Below are explanations for each mode and examples to illustrate. See note at
left.
1. WEIGHT>NORMAL mode
This is used for entering batches based on weight or by percentage if
adding up to 100, 1000 or 10000.
2. WEIGHT>ADJUST mode
This is based on weight or by percentage, same as #1 above. The
difference is that after the first ingredient is loaded, the rest of the
ingredients will be adjusted accordingly depending on how far off the
first ingredient was from the target. This maintains a proper ration
balance.
3. HEAD.CT mode
This mode is based on entering recipes with weight amounts to feed 100
head.
When a recipe is programmed, it remembers the mode the indicator was in at the time
of recipe creation. This means you can have some recipes based on head counts and
some based on weight.
IMPORTANT: Make sure the indicator is configured properly before entering recipes.