Instruction manual

Model 1040/XL User Instructions 17
5.3 Loading Or Unloading Ingredients By Using the XM64
6. Press the GROSS key to shut off the alarm and the display will return to the
gross mode. Press ZERO/CLEAR to shut off alarm and remain in the Load/
Unload mode with the previous target amount active. This is very handy for
loading/unloading a series of equal amounts.
7. If AUTO-HOLD is enabled…
The alarm shuts off and the indicator goes into Auto-Hold mode,
displaying HOLD)
If AUTO-HOLD is off…
The alarm shuts off, and the unit returns to the gross mode.
8. Move mixer to its next ingredient loading/unloading location…
Display shows HOLD. Because the unit is in HOLD mode it will not allow
the display weight to change because of the terrain. This will prevent a
scale zero shift. Press MENU (or XM64) or GROSS key to return to
Gross mode.
5.3 Loading Or Unloading Ingredients By Using the XM64
You can load or unload a series of ingredients or batched feed by using the XM64
transmitter/receiver. You must know the net amount to be loaded or unloaded. The
XM64 gives you the ability to tare or zero each ingredient and view the net amount as
you load or unload. The remote can also be used to indicate the gross amount between
ingredients and can return the indicator to the gross mode when done loading by simply
holding down on the XM64 for three or more seconds.
Follow these steps:
1. Be sure the mixer or scale system is empty and zero the indicator.
2. Press the LOAD/UNLOAD key…
Zero value is shown, and the load and lb/kg annunciators turn on. This
means the net weighing mode is on.
3. Load or unload material as needed…
Net weight value increases. This is an absolute weight value. If you are
loading or unloading it shows the amount loaded or unloaded so far.
4. When you reach the proper amount, stop loading or unloading material.
The alarm light is nonfunctional in this loading/unloading sequence.