Specifications

01/02 Rev. 2.13-02 MANUAL Attachment, Setup, Service, Page 9
TCS
Servicing notes
Safety
For your own safety, you must observe the following instructions whenever
carrying out servicing work:
CAUTION!
Danger of cuts to hands and fingers!
– Switch the unit off and unplug it before servicing work!
– Touching the blades even while the printer is disconnected can lead to
cuts if you are not paying attention!
– Take extreme care when carrying out setup work which requires the
unit to be operated!
– Refit safety devices when the servicing work is completed!
General notes
Locking varnish

Do not under any circumstances unscrew any screws secured with red
locking varnish! They secure settings which can only be made in the
factory.
Screws secured with blue paint are for different settings. They may be
unscrewed for servicing work – afterwards they must be secured again!
View

Unless otherwise expressly stated, the views in the description designate:
left = motor side of the stacker, front = material feed direction.
