Specifications

01/02 Rev. 2.13-02 MANUAL Attachment, Setup, Service, Page 5
TCS
Setting up the stacker
Activating/deactivating the textile stacker
After the textile stacker has been connected, it is necessary to set the
printer for stacker operation. The textile stacker is activated by setting the
appropriate parameter in the printer parameter menu.

Activating an option which is not present can cause the device to
malfunction. Danger of injury!
Activate the textile stacker as follows:
Task Display
1. Connect the printer
and switch on.
OFF
2. Press FEED+CUT
button several times
until:
INFO
3. Repeatedly press CUT
button until:
SYSP
4. Press ENTER button: EMUL
5.
Repeatedly press CUT
button until:
PEPH
6. Press ENTER button: NONE
7. Repeatedly press CUT
button until:
TCS
8. Press FEED+CUT
button:
SYSP
9.
Press FEED+CUT
button:
OFF

In order to deactivate the textile stacker, set the parameter PEPH from
TSTA back to NONE.
An overview of all the parameters and possible settings can be found in
topic section "Info-Printouts and Parameters".