Specifications

01/02 Rev. 2.13-02 MANUAL Attachment, Setup, Service, Page 4
TCS
Attaching the stacker
1. Switch the printer off and remove the
mains plug.
2. Remove the printer cutter cover (1). To
do this, unscrew the two Allan key lock
screws (2).
3. Screw on the stacker connector (3). The
borehole (4) must point downwards.
4. Twist out the shaft (5) until there is a
gap of approx. 2 cm at the bottom.
5. Hang the stacker lock flange (7) into the
stacker connector (3). Place the
borehole flange (8) over the upper
connector (9) bolt head. At the same
time, the recess (10) must sit on the
thread bolt (11) which holds the shaft
(5).
6. Hold the stacker in position and secure it
to the shaft by turning the red winged
head.
7. Plug the stacker connector plug into the
15-pin socket on the front of the printer.
Tighten the two lock screws by hand or
with a screwdriver.

It is essential that you switch
the printer off before
plugging or unplugging the
TCS, otherwise the
electronics of the device could be
damaged!
Tools
Allan keys, 3 and 4 mm
2
3
1
2
3
9
4
5
8
10
5
7
11