Specifications

01/02 Rev. 2.13-02 MANUAL Attachment, Setup, Service, Page 3
TCS
Safety notes
CAUTION!
Danger of cuts to hands and fingers!
– Do not remove safety devices!
– Do not bypass safety devices!
– Disconnect the printer before installing the TCS!
– Do not touch the blades even when the unit is switched off!
Safety devices
The TCS is fitted with the following safety devices in order to protect the
user against physical damage caused by cuts or squeezing/crushing
injuries.
Safety device Figure Function Check
Front plexiglass
cover
Lid switch
Prevents access to the
cutter.
The printer and stacker
will stop if the cover is
opened during (printing
or cutting) operation.
A visual check is
sufficient: Is the cover
in place?
Functional check: The
printer and TCS must
stop if it is opened
during (printing or
cutting) operation.
Display: ST52
Rear plexiglass cover Prevents access to the
cutter.
A visual check is
sufficient: Is the cover
in place?
Fig. 1: Safety devices on the TCS. Make sure that all safety devices
are in place and functioning properly!